Networking

Overview

A node has to communicate with other nodes on the network, in order to exchange useful information. To accomplish this task, the Lekan leverages the battle-tested libp2p framework.

The choice to go with libp2p is primarily focused on:

Speed - libp2p has a significant performance improvement over devp2p (used in GETH and other clients)

Extensibility - it serves as a great foundation for other features of the system

Modularity - libp2p is modular by nature, just like the Lekan. This gives greater flexibility, especially when parts of the Lekan need to be swappable

GRPC

On top of libp2p, the Lekan uses the GRPC protocol. Technically, the Lekan uses several GRPC protocols, which will be covered later on.

The GRPC layer helps abstract all the request/reply protocols and simplifies the streaming protocols needed for the Lekan to function.

GRPC relies on Protocol Buffers to define services and message structures. The services and structures are defined in .proto files, which are compiled and are language-agnostic.

Earlier, we mentioned that the Lekan leverages several GRPC protocols. This was done to boost the overall UX for the node operator, something which often lags with clients like GETH and Parity.

The node operator has a better overview of what is going on with the system by calling the GRPC service, instead of sifting through logs to find the information they're looking for.

GRPC for Node Operators

The following section might seem familiar because it was briefly covered in the CLI Commands section.

The GRPC service that is intended to be used by node operators is defined like so:

The Lekan also implements several service methods that are used by other nodes on the network. The mentioned service is described in the Protocol section.

Top